Epoxy Top-Coat Enamel

Home>INDUSTRIAL COATINGS>INDUSTRIAL OIL BASED FINISHES>Epoxy Top-Coat Enamel

Description

EPOXY TOP-COAT ENAMEL is a unique industrial coating specially formulated for use under some of the most stringent industrial conditions on metal, wood, cured concrete.
Use:
 Best for bulk storage tanks, silos, superstructure, ridges, floors, driveways, etc.
Properties:
  •  Very- hard, high gloss finish
  •  Resists most industrial and atmospheric acids and alkali
  •  Resistant to Erosion, Water, and Impact
  •  Very good adhesion to properly primed ferrous and nonferrous metals
Finish:
 High Gloss
Coverage: 175-200 Sq. Feet per gallon depending on Surface Conditions, Porosity, Absorption, Film Thickness, etc.
Thinning and Clean-up: Thinning is generally not recommended. Use Arbo Special Lacquer Thinner for cleaning equipment and spillage.
Re-Coat Time: Allow 24 hours drying before recoating, sand lightly between coats.

Available in:               1 Gallon and 2 Pints
Available colours:  White, Red, Green, and Gray

Note: TORGINOL TOP-COAT EPOXY ENAMEL is a two-pack system-(Base and Converter) that must be mixed thoroughly in the ratio of 3- parts Base: 1 Part Converter and is allowed to induct for one hour before being applied. Failure to allow sufficient induction will defeat expected results. Mix only the amount needed for the job. The unused mixture cannot be stored as it will cure. Pot life after mixing is approximately three hours.

What is induction time?

Answer: These terms refer to the waiting period required between the time you mix and the time you can start applying a two-part product, such as an epoxy. This allows the necessary chemical reactions between the two parts to begin so the coating will cure and perform properly.